FXLion Nano Pro 14.4V/98Wh V-Mount Battery - dostupno odmah!

Tilta Hydra X Dan Ming Speed Pan System - na stanju!

Tentacle Sync E Timecode Generator - profesionalno rešenje!

Nanlux Evoke 150C LED Full-Color Spot Light - dostupno odmah!

Naslovna WIRELESS AUDIO Lectrosonics DSSM
Lectrosonics DSSM

Lectrosonics DSSM

Lectrosonics DSSM water-resistant micro belt pack transmitter, Lemo 3p input

Izdvajamo
2,095.00 € 2,395.00 € -13%
Cene su izražene bez PDV-a i mogu varirati u skladu sa promenama troškova transporta i uslovima na tržištu.
Lectrosonics
✓ Na stanju - spremno za slanje
  • Opis proizvoda
  • Specifikacija
  • Pakovanje
The DSSM is the enhanced, fully digital successor to the SSM, while being IP57 rated for watertightness and offering dock charging capability.

The IP57 rating indicates that the unit is protectedagainst dust ingress while also withstanding water immersion up to 1 meter for 30+ minutes – perfect for the most demanding work environments. All while allowing for quick battery swap-outs.

The DSSM is ideal for theater, TV, film and broadcast environments where concealment and water-resistance is required. The DSSM offers an extensive feature set and performance packed into an exceptionally compact housing, compatible with all current Lectrosonics digital receivers, including the DSQD, DCR822, DSR, DSR4, M2Ra, and DCHR.

The DSSM includes specially developed, high efficiency circuitry for extended operating time on the rechargeable LB-50 battery. RF power selections are offered at 10 and 35 mW (D2 compat mode) and a special high density (HDM) mode at 2 mW.

The servo bias input accepts mic or line level signals with a wide range of gain adjustment in 1 dB steps. Accurate indications on the display allow precise gain adjustments to be made for the maximum signal to noise ratio and minimum distortion. The limiter in the preamp can cleanly handle signal peaks over 30 dB above full modulation, allowing the input gain to be set high enough to achieve the maximum signal to noise ratio, yet provide protection against input overload.

The audio input jack is a common subminiature 3-pin connector with a threaded collar adding additional rug- gedness. An IR (infrared) port next to the antenna allows transfer of frequency and compatibility mode settings, and encryption keys.

The membrane switch panel and OLED display enable access to all adjustments and settings. The menu structure is easy to navigate. Battery status is indicated by a defeatable bi-color LED that is green with a fresh battery, then turns to red as the battery runs down, and finally starts blinking red when there are only a few minutes of runtime remaining. The housing is constructed of machined aluminum alloy treated in the conductive, super hard electroless nickel ebENi finish.

A flexible, repositionable wire belt clip (to orient the antenna facing up or down) is included. The optional CHSDSSM battery charging station provides a convenient and organized means of recharging up to 4 LB-50 batteries or DSSM transmitters in larger systems with numerous batteries in regular use. Each charging module may be daisy-chained to 3 additional modules using a single AC-DC power supply (DCR5/9AU - not included) for a total of 16 units charging at once (LB50’s and/or DSSMs).

Features:

Extremely compact - ideal for theater and

sports broadcasting

IP57 rated for moisture resistance

High density mode for maximum channel counts in limited spectrum

Selectable power; 10 or 35 mW (D2 mode)

Offers over 6000 frequencies across a wide UHF range

Two-way IR port for easy set-up

Firmware updates via USB/Wireless Designer

Wide range input gain control in 1 dB steps

Dock chargable with optional CHSDSSM unit

Operating Frequencies:
DDSSM - A1B1 470.100 - 607.950
DSSM/E01-A1B1470.100 - 614.375
DSSM-B1C1 (US) 537.600 - 607.950
614.400 - 615.950
P57 ratingthe DSSM will resist water ingress for 30 minutes or more when submerged under 1 Meter of water (in our tests it went for hours!)
Removeable batteryThe DSSM uses our LB-50 rechargeable LiOn battery (PN#40106-1) from the IFBR1B and SSM products. This means that existing charging bays like the CHS12LB50, CHS12LB50a, and 40117 dual USB charger can be used with this new transmitter.
Easy-to-use onboard buttons and rich display, with the same menu structure as our venerable DBSM family transmitters
USB jack located inside the battery compartment for firmware updates in the field, using Wireless Designer software
Drop-in charging with the optional CHSDSSM charging bay. This bay charges 4 units or batteries and can be connected to additional units so that up to 16 batteries or units in any combination can be charged from a single DCR5/9AU power supply (just like for the similar CHSIFBR1B).
All-metal construction
Removeable antenna with SMA mount
Standard miniature 3-pin connector
RF Power settings at 10 and 35 mW in D2 mode and 2 mW for HDM mode
AES 256-bit CTR encryption with four key policies including Universal, Shared, Standard, and Volatile. This covers a wide variety of use cases including government, corporate, & sports coverage
Compatible with DSQD, DCHR, M2Ra, DSR, DSR4, and DCR822 receivers
653.050 - 662.950
DSSM/E01-B1C1537.600 - 691.175
DSSM/E07-941941.525 - 951.575
953.025 - 956.225
956.475 - 959.825
Frequency
Selection
Steps25 kHz
RF Power outputSelectable; 10, 35 mW or 2mW (HD mode)
Compatibility
ModesHDM or D2 (all models)
Frequency Stability± 0.002%
Spurious radiationCompliant with ETSI EN 300 422-1
Equivalent input
noise–120 dBV (A-weighted)
Input levelNominal 2 mV to 300 mV, before limiting. Greater than
1V maximum, with limiting.
Input impedance• Mic: 300 or 4.5 k ohm; selectable
• Line900 ohm
• Instrument1 M ohm
Input limiterDSP controlled, dual envelope “soft” limiter with
greater than 30 dB range
Gain control range-7 to +44 dB; digital control, 1 db steps
Modulation
indicatorsDual bicolor LEDs indicate modulation of -20, -10, 0
and +10 dB referenced to full modulation
Audio Performance:
Frequency Response35-20 kHz; 35-15 kHz (HDM compat mode)
Low frequency
roll-offSelectable; 35, 50, 70, 100, 120, 150 Hz
THD0.2% (typical)
ControlsFront panel membrane switches with OLED interface
for power on/off and all setup and configuration
controls
Audio Input JackSubminiature; locking
AntennaSMA connector; coated, flexible wire, length by
frequency band
BatteryLithium-ion 3.6 V 1000 mAH LB50 battery pack (included)
Battery Life6 hours per charge @ 35 mW
Weight3.5 ounces (100 grams) including lithium battery pack
Dimensions
(housing)2.59 x 1.9 x .70 in. (10.0 x 49 x 17 mm)
Emission
Designator110KG1E (HD mode); 170KG1E (D2 mode

U pakovanju se nalazi:

  • 1x DSSM Digital Miniature Water-Resistant Transmitter